123 Ignition distributor installation

Installing the 123 Ignition distributor should have been a straight-forward task, but the Bosch unit threw us a curveball. When I was removing the later, the oil seal fell off and onto the drive gear. Since it is dark, and filled with a minute amount of oil, the o-ring completely disappeared.

That pesky little piece of rubber prevented us from installing the new distributor - and caused about an hour and half of head scratching. Eventually we found the problem and everything was a bit more straight-forward.

Once we went through the installation procedure, including programming the unit from my iPhone, the engine ran better immediately.

Alfaholics recommended curve:

The next day I ran all the wires inside some automotive wiring tube and made everything neat and tidy.

Front suspension torque settings

Lowering kit installation part 2

With the rear suspension finished, we moved to the front of the car. Our first task was to remove the sway bar.

Next, we used the Alfaholics 'Spring Tool' and a hydraulic jack to drop the spring assembly. It takes about 20 minutes per side.

When the front spring pans drop, be prepared for a shower of rust and dirt.

The aluminum pan spacers were completely corroded and beat up. Fortunately, the lowering kit does not use them.

Everything else, the pans and seats, was in good shape. So we cleaned, sanded and painted these parts.

The rubber donuts looked brand new after washing.

Again, the [old] front dampers were seized.

The Koni Sport dampers went in easy. I used one twist on the front, and the factory settings (full soft) for the rear.

Installing the lowered springs takes some time. We used the installation tool and a hydraulic jack to lift the assembly.

New 29mm sway bar installed.

Sump guard back on.

Lowering kit installation part 1

Over the past two weekends, we installed the Alfaholics lowering kit.

We started with the rears, which involves dropping the rear seat to access the damper 'hats.'

Old Bilstein shocks out. One side was completely seized while the other was very stiff.

We used spring compressors on the passenger side. This proved to be a waste of time. Putting a hydraulic jack under the rear pan works fine and is much faster.

The new spring is much shorter and lighter.

New Koni Sport damper & lowered spring in. The axel straps had to be shortened about a 3/4 of an inch.

We also removed the rear sway bar. The rear arm bushes looked excellent, but the T-bar bushes will need replacing - another project!

More upgrades

I've been making a list of "things to do" while driving the car.

The handling of the car seems a little "off." When you are driving around, the shocks seem to stick in certain positions and the stance of the car is always changing.

I've also found that the timing can be erratic. You will hear backfires through the carbs as you accelerate from red lights, etc.

In both cases, the suspension and the ignition, I suspect the original parts are worn out. So I ordered an Alfaholics suspension kit and an electronic distributor (123 Ignition) last week.

My plan is to start the upgrades this coming weekend.

Rear diff oil changed & more miles

Some more small tasks done.

Yesterday, I changed the rear differential oil - which looked / smelled old, but not completely foul. The new Redline 75W90NS made a small difference when I took the car out for a test run. Another job done.

I also spent about an hour cleaning the interior & conditioning the leather. It takes a lot of elbow grease to remove the years of dirt and dust!

The car, and most noticeably the engine, is starting to loosen up as I put more miles on it. When leaving from a standing start, there is an occasional 'klunk' coming from the rear end. So it looks like I'm going to need to track down a worn bushing...

More miles

I tweaked the timing a little and put another 40 miles on the car --- running beautifully.